Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across The Heights
If you’re searching for chimney cap and crown work in The Heights, the short answer is this: a properly built crown and a correctly sized cap are what keep water off the top of your stack and out of the flue below. We handle both, plus the multi-flue setups that The Heights’ attached bungalows demand. Our technicians have up to 14 years of experience, and we know this neighborhood’s housing stock: 1920s-40s bungalows on tight lots where one stack may serve more than one fireplace. The estimate is free and written before any work is booked. Call (844) 299-4971. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Why The Heights Homeowners Call Chimney Sweep Garden Oaks for Chimney Cap & Crown
We specialize only in chimney and fireplace work. That matters in a preservation-district neighborhood where a bad crown repair can scar original brick and a badly sized cap can leave half a shared stack open to the weather.
One company handles the entire system, from the firebox to the cap, so you’re not coordinating a mason, a roofer, and a sweep who each blame the other. When we install a cap or rebuild a crown, we document what we found with a Level 2 inspection aligned to NFPA 211, and we show you the photos. Nothing is recommended without evidence you can see for yourself.
For The Heights specifically, we plan the cap and the crown together. On a detached suburban chimney you can treat them as separate jobs. Here, they interact: the crown sheds water away from the top of the stack, and the cap keeps rain and animals out of the flue mouth. Fix one and skip the other and you’ve solved half the problem.
We tell you what your chimney actually needs. If the crown can safely wait a season, we’ll say so and put it in writing.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in The Heights
Cap Installation in The Heights
A new cap goes on after we measure the flue opening and check the crown it will sit on. In The Heights, we often specify a chimney cap & crown scope together, because the cap anchors just above a crown that may be thin or cracked. We install Gelco and Famco caps sized to the flue, not a generic round cover that leaves gaps.

Multi-Flue Cap for Shared Stacks
This is the sub-service that comes up most in The Heights. When two or three flues on an attached or closely spaced bungalow share one masonry stack, a single small cap on one flue leaves the others wide open. A properly built multi-flue cap covers every opening on that stack at once, so wind-driven rain and nesting animals can’t drop into a flue that isn’t even yours.

Crown Repair in The Heights
Original crowns on 1920s-40s stacks are usually a thin mortar wash with no overhang, and Houston’s humid air and occasional freezes crack them. We rebuild the crown with a proper overhanging profile so water runs off the edge and away from the brick below. On historic homes we match the surrounding masonry so the repair doesn’t stand out.

Crown Coating in The Heights
Where the crown is still structurally sound but show hairline cracking, a crown coating can seal the surface and add years before a rebuild is necessary. It’s not a substitute for reconstruction when the mortar has failed, and we’ll tell you which one your crown needs.
Cap Replacement
A rusted, loose cap on a 1940s bungalow usually means decades of moisture and a failed fastener, not a bad cap to begin with. We remove it, inspect the flue and crown underneath, and set a new one from Olympia Chimney or Famco. You’ll know what’s beneath it before we cover it again.
Custom Cap
Odd flue sizes and multi-flue stacks in The Heights sometimes need a custom-built cap. We measure on site and have one fabricated to fit the opening precisely.
Trusted Brands We Service in The Heights
We work with the same materials chimney professionals specify nationwide: Gelco, Famco, Olympia Chimney, and HeatShield for flue tile repair and resurfacing when the crown work turns up damaged tiles below. These are professional-trade products, not big-box substitutes, and we install them to the manufacturer’s spec. We don’t claim to stock parts locally; we specify and install the right component for your stack. If a crown repair exposes a spalling or unlined flue, HeatShield ceramic resurfacing can sometimes extend its life without a full reline, and we’ll explain when that’s appropriate and when it isn’t.
Common Chimney Cap & Crown Problems We See in The Heights Homes
- Thin mortar-wash crowns on 1920s-40s stacks. The original crowns were often just a skim coat with no overhang, and they crack and spall. Houston’s humid air and rare freezes then work on the clay flue tiles underneath.
- A single cap on a shared stack. In The Heights’ attached and closely spaced bungalows, one small cap over one flue leaves the neighbor’s flue open. Wind-driven rain and one appliance’s exhaust can reach a flue that isn’t theirs.
- Gas-log conversions with an unlined, uncapped flue. Many fireplaces here were converted to gas logs years ago, but the gas connection often bypasses the damper. The flue sits unlined and uncapped, so animals nest and moisture gets in unnoticed for years.
- Rusted, loose caps from hurricane-season weather. Driven rain and wind degrade caps over time, and a cap that’s pulled loose no longer keeps anything out.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Cap & Crown in The Heights, TX
Here’s what cap and crown work typically runs in The Heights. A standard single-flue cap installation generally falls in the $250-$550 range. A multi-flue cap for a shared stack usually runs $450-$900 depending on how many flues it covers. Crown coating is typically $350-$650, and a full crown rebuild runs $600-$1,400, more when the surrounding brick or flue tiles need attention too. These are estimates for this market; the written estimate sets the final price, and that estimate is free. If your crown can safely wait, we’ll tell you and say so plainly.
We Also Serve Cities Near The Heights
We work across the surrounding area, including Garden Oaks, River Oaks, Montrose, and Oak Forest. If you’re in one of those neighborhoods and need cap or crown work, the same process applies: a Level 2 inspection, photos, and a written estimate. We serve The Heights and these neighboring communities with the same attention to shared stacks and aging masonry.
Serving The Heights, TX – Our Local Coverage Area
We serve The Heights and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in The Heights
Yes. A shared stack needs a multi-flue cap that covers every opening on it, not a single small cap over one flue. Leaving the other flues open lets wind-driven rain and one unit’s appliance exhaust reach a flue that isn’t yours. Call (844) 299-4971 for an exact quote – estimates are free.
Because burning isn’t what cracks those crowns. The original thin mortar wash takes on Houston’s humid air and the occasional freeze, and it spalls over time whether or not you use the fireplace. A crown rebuilt with a proper overhanging profile sheds that water. Call for an assessment.
Yes, and we do. We run a Level 2 inspection and document the flue condition with photos before a cap goes on, because a cap over an unlined or damaged flue just seals a problem in place. You’ll see exactly what’s beneath the crown before we cover it.
Usually it means decades of moisture and a failed fastener loosened the cap, not that the cap was bad to begin with. When we replace it, we inspect the flue and crown underneath so the new cap sits on a sound stack. Call (844) 299-4971 to book an assessment.
Often, yes. The cap anchors just above the crown, so a thin or cracked crown won’t hold it properly and will keep letting water into the flue below. We plan crown repair and cap together in The Heights, because on a shared stack they work as one system. Estimates are free.
Get a Free Estimate on Cap & Crown Work in The Heights
If your crown is cracked or your cap is loose, the right move is to inspect before you cover it up. We’ll run a Level 2 inspection, show you the photos, and quote the work in writing. No upsell, no scare tactics. Call (844) 299-4971 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Garden Oaks.